Kirkland Chimney Pros logo

Woodinville, King County

Chimney Flashing Repair in Woodinville, WA

Chimney flashing repair in Woodinville runs $375 to $1,500. Where the metal is sound and only the sealant has let go, we reseal, and the bill stays low. New step and counter pieces on every side, or a cricket built behind a broad stack, bring it up toward the ceiling. Those strips of metal are the joint between masonry and shingles, and they are the usual first suspect when a chimney leaks.

Typical investment

$375–$1,500

  • Serving Woodinville and the rest of our King County territory
  • $99 plus tax on-site inspection, credited toward an approved quote
  • Usually on the same route as Kirkland, Bothell, Kenmore
  • Local crews
  • Licensed & insured
  • Documented work
  • Written quote first

Book an inspection

Book your $99 inspection

$99 plus tax, deducted when you approve the repair

Service
Town

Book your $99 inspection

Pick a real open slot on our crew's calendar — takes about a minute.

  • No payment to book
  • Written on-site quote
  • Photos of every job
  1. 1
  2. 2
  3. 3
  4. 4

Chimney Flashing Repair in Woodinville

Pick a date
October 2026
Su
Mo
Tu
We
Th
Fr
Sa
Open times

Loading open times…

Not sure where to start

What's going on with your chimney?

Pick what you're seeing at your Woodinville home — we'll point you to the right fix.

What we do

Other chimney services in Woodinville

The same crew, the same written quote — for Woodinville homes.

Ranges shown for orientation — the exact figure is written up on-site, after the inspection.

Why Woodinville homes need chimney flashing repair

Woodinville's wet season lasts from early October to early May, and the windier months, mid-October to mid-April, overlap almost all of it, according to WeatherSpark. Rain driven sideways against a chimney tests every seam in the flashing, especially on the side of the stack facing the weather.

One inspection a year, however often you burn

The Census counts only about five Woodinville homes that rely on wood as their main heat, out of roughly 5,400 occupied homes. For almost everyone else, the fireplace or stove is used on cold evenings, not every day.

Light use does not buy a pass, though. The fire code standard CSIA points homeowners to, NFPA 211, sets a once-a-year check as the minimum for every chimney, fireplace and vent. That yearly look is also when failing flashing is usually spotted, before a stain appears indoors.

Your chimney flashing repair in Woodinville: what's included

Every chimney flashing repair we do in Woodinville includes:

  • Leak tracing around the full chimney base
  • Removal of failed sealant and loose metal
  • Step flashing along the roof slope
  • Counter flashing cut into the mortar joints
  • Cricket behind wider chimneys when required
  • Photos of the finished seal

Signs you need chimney flashing repair in Woodinville

  • Ceiling marks spreading from the chimney wall
  • Drips in the attic during heavy rain
  • Sealant cracked or peeling at the roof line
  • Metal lifted away from the brick or chase
  • Rotten decking around the stack

Smoke coming back into the room, or a smell that won't go? Book the inspection first.

Book now

Why Woodinville homes need it

Many homes here are from the 1980s and 1990s, and a good number have had at least one new roof since. Flashing is often the part that gets reused, patched with sealant or bent back into place during a reroof. Years later, the sealant has dried and cracked, and water finds the gap between the metal and the chimney face.

Height, clearance and where sparks land

Under Washington's residential code, the top of a chimney has to sit 3 feet or more above its roof exit and top every part of the building within 10 feet by at least 2 feet. That height aids the draft and keeps sparks off the nearby roof.

Woodinville Fire & Rescue gives the same ten-foot rule for open flames outdoors: keep them that far from houses, structures and vegetation. When we rebuild flashing, we also note a chimney that sits too short for its roof, because a reroof sometimes changes the heights around it.

Your chimney flashing repair in Woodinville, step by step

  1. 1

    Trace the water

    We check the flashing, the crown, the cap and the chimney face, so the fix goes where the water actually enters.

  2. 2

    Decide: reseal or replace

    Sound metal with failed sealant is resealed; bent, rusted or short flashing is replaced, and the quote says which.

  3. 3

    Rebuild the seal

    New step flashing is layered in with each course of shingles; a counter flashing, let into a groove in the brick above, then laps over it to shed water.

  4. 4

    Check and photograph

    We photograph every side of the finished work, so you can see what sits under the shingles.

Chimney Flashing Repair prices in Woodinville

What this work is quoted at for Woodinville homes — the exact figure comes from the $99 on-site inspection, credited toward the work.

Chimney Flashing Repair prices in Woodinville — published rates, 2026
ServicePrice in WoodinvilleWhat that covers
Chimney Flashing Repair$375–$1,500Reseal at the low end, full flashing replacement at the high
Chimney Sweep$189–$459Full flue swept, Level 1 inspection included
Chimney Inspection$99 plus taxLevel 1 visual; Level 2 adds a full camera scan
Chimney ReliningFrom $1,900Full-length stainless liner, sized to the appliance
Chimney RepairFrom $425Masonry repair — brick and mortar, scoped after diagnosis

Ranges are what these jobs are quoted at in Woodinville. The exact figure is set on site after a $99 inspection (credited toward the job if you go ahead), and you approve it before any work starts.

Around Woodinville

Woodinville is a Sammamish River valley city first homesteaded by the Woodin family in 1871, on the Sammamish River and Little Bear Creek, with homes with a median build year of 1995, fewer than one in five of them older than 1980. We work every part of it — West Wellington, East Wellington, Woodinville Heights, Upper West Ridge included.

WoodinvilleKing County, WA · 47.754, -122.163

Before and after

What the work changes

Illustrations of what each repair changes on a typical chimney — not photos of a specific job.

The local chimney sweep crew serving Kirkland, WA

From booking to done

Four steps, each one on paper — so you always know what happens next.

  1. 1

    Book online

    Choose a genuine opening on the crew's calendar. Confirmation is immediate.

  2. 2

    On-site inspection

    Liner, crown, cap, flashing and masonry examined in order — each finding photographed.

  3. 3

    Written quote

    One document, plain numbers, covering only the work your chimney genuinely needs.

  4. 4

    Work done & documented

    The repair is completed, then handed over with before-and-after photos of every item.

Chimney Flashing Repair in Woodinville — common questions

How much does flashing repair cost in Woodinville?

$375 to $1,500. A reseal prices near the bottom; a full replacement or a new cricket prices near the top.

What is a cricket, and do we need one?

A small peaked ridge built on the uphill side of the chimney to divide the water around it. Washington's residential code requires one behind any stack over 30 inches across whose top side does not reach the ridge.

Should we fix flashing when we reroof?

Yes, that is the ideal time. New roofing around old flashing often leaks at the chimney first.

Get in touch

Book an inspection

Need your chimney checked in Woodinville?

A $99 on-site inspection, a written quote before any work, and photos of every item we touch.

Call (425) 793-2992Book